_____________________________________________________
Guide Provided By: GamingGen
Estimated Time: 15min - 1hour
Experience Level: Intermediate
Items Used: 15 watt soldering iron, small diameter solder, tweezers or small needle nose pliers
_____________________________________________________
Below is a picture that shows what way the LED's should be installed on a slim Xbox 360 PCB board. If you do not know how to remove or install 0603 LED's, check out this OLDER GUIDE. Be careful not to take off any resisters when removing/installing the LED's. Taking off the center LED is easy, simply blob up each side with solder and wipe it off w/ your soldering iron! Just be sure not to use to much solder as you do not want to make a mess. We used 2 0603 LED's to replace the center LED. You can use a 0805 LED, but the color is usually not the exact same. Remember w/ the center LED, the left LED turns on when you power on the Xbox 360. The right LED only displays when there is an error on your Xbox 360.
View Original |
